Bartosz Golaszewski 6e0022b5ae net: phy: aquantia: fix system interface type not updated in forced mode ... aqr_gen1_read_status() decodes the MDIO_PHYXS_VEND_IF_STATUS register to determine which SerDes interface the PHY is currently using on its system side and stores the result in phydev->interface. phylink relies on this value to configure the MAC. The autoneg == AUTONEG_DISABLE check is not correct: MDIO_PHYXS_VEND_IF_STATUS is set by the PHY firmware based on the negotiated link speed, not based on whether autoneg was used to reach it. When the link comes up at 1G in forced mode, the register correctly reads SGMII, but the early return prevents phydev->interface from being updated. It stays at whatever value it held before (typically 2500BASE-X from the initial autoneg run), so phylink configures the MAC for the wrong interface and the link cannot come up. Remove the autoneg guard so that the system interface type is always decoded when the link is up. Cc: stable@vger.kernel.org Fixes: 110a2432c5 ("net: phy: aquantia: add downshift support") Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski@oss.qualcomm.com> Link: https://patch.msgid.link/20260923-qcom-sa8255p-emac-v15-1-e82f33720737@oss.qualcomm.com Signed-off-by: Paolo Abeni <pabeni@redhat.com>		2026-10-01 10:15:19 +02:00
..
aquantia	net: phy: aquantia: fix system interface type not updated in forced mode	2026-10-01 10:15:19 +02:00
mediatek	net: phy: mediatek: do not report link and per-speed LED rules together	2026-09-14 19:01:51 -07:00
mscc	Convert 'alloc_obj' family to use the new default GFP_KERNEL argument	2026-02-21 17:09:51 -08:00
qcom	net: phy: qcom: at803x: Fix IPQ5018 short-cable DAC values	2026-09-29 18:31:35 -07:00
realtek	Merge git://git.kernel.org/pub/scm/linux/kernel/git/netdev/net	2026-08-13 11:00:14 -07:00
adin.c	net: phy: adin: enable configuration of the LP Termination Register	2026-01-15 19:36:04 -08:00
adin1100.c
adin1140-phy.c	net: phy: Add support for the ADIN1140 PHY	2026-07-21 10:53:24 +02:00
air_an8801.c	net: phy: air_an8801: ensure maximum available speed link use	2026-05-27 18:39:24 -07:00
air_en8811h.c	net: phy: air_en8811h: move LED GPIO configuration to config_init	2026-08-27 11:47:01 +02:00
air_phy_lib.c	Merge git://git.kernel.org/pub/scm/linux/kernel/git/netdev/net	2026-05-28 14:02:21 -07:00
air_phy_lib.h	Merge git://git.kernel.org/pub/scm/linux/kernel/git/netdev/net	2026-05-28 14:02:21 -07:00
amd.c
as21xxx.c	Convert 'alloc_obj' family to use the new default GFP_KERNEL argument	2026-02-21 17:09:51 -08:00
ax88796b_rust.rs
ax88796b.c
bcm-cygnus.c
bcm-phy-lib.c	net: phy: broadcom: Save PHY counters during suspend	2026-05-07 08:36:47 -07:00
bcm-phy-lib.h	net: phy: broadcom: Save PHY counters during suspend	2026-05-07 08:36:47 -07:00
bcm-phy-ptp.c
bcm7xxx.c	net: phy: broadcom: Save PHY counters during suspend	2026-05-07 08:36:47 -07:00
bcm63xx.c
bcm87xx.c
bcm54140.c
bcm84881.c	net: phy: bcm84881: add LED framework support for BCM84891/BCM84892	2026-04-02 17:59:43 -07:00
broadcom.c	net: phy: broadcom: Save PHY counters during suspend	2026-05-07 08:36:47 -07:00
cicada.c
cortina.c
dap8211r.c	net: phy: add DAPU Telecom DAP8211R(I) Gigabit Ethernet PHY driver	2026-08-10 15:30:25 -07:00
davicom.c
dp83tc811.c	net: phy: DP83TC811: add reading of abilities	2026-05-14 15:17:12 +02:00
dp83td510.c	net: phy: dp83td510: handle the active-high LED polarity mode	2026-09-10 08:47:22 -07:00
dp83tg720.c
dp83640_reg.h
dp83640.c	net: phy: dp83640: fix per-bus clock lifetime	2026-08-13 17:30:15 -07:00
dp83822.c	net: phy: dp83822: Add optional external PHY clock	2026-06-02 11:38:00 -07:00
dp83848.c
dp83867.c	net: phy: dp83867: handle the active-high LED polarity mode	2026-09-10 08:02:06 -07:00
dp83869.c	net: phy: dp83869: fix setting CLK_O_SEL field.	2026-04-28 15:51:55 +02:00
et1011c.c
fixed_phy.c	net: phy: fixed_phy: replace IDA with a bitmap	2026-01-13 18:58:49 -08:00
icplus.c
intel-xway.c	net: phy: intel-xway: workaround 100BASE-TX Link-Up issue	2026-09-24 10:21:20 -07:00
Kconfig	net: phy: add DAPU Telecom DAP8211R(I) Gigabit Ethernet PHY driver	2026-08-10 15:30:25 -07:00
linkmode.c
lxt.c
Makefile	net: phy: add DAPU Telecom DAP8211R(I) Gigabit Ethernet PHY driver	2026-08-10 15:30:25 -07:00
marvell-88q2xxx.c
marvell-88x2222.c	net: phy: marvell-88x2222: Support SFP through phy_port interface	2026-01-13 18:52:35 -08:00
marvell.c	net: phy: marvell: fix return code	2026-07-20 17:51:46 -07:00
marvell10g.c	net: phy: marvell10g: Support SFP through phy_port	2026-01-13 18:52:35 -08:00
mdio_bus_provider.c	Networking changes for 7.1.	2026-04-14 18:36:10 -07:00
mdio_bus.c	net: phy: move remaining provider code to mdio_bus_provider.c	2026-03-14 12:23:02 -07:00
mdio_device.c	net: phy: drop duplicated header include in mdio-device	2026-07-21 08:28:49 -07:00
mdio_devres.c
mdio-open-alliance.h
meson-gxl.c
micrel.c	net: phy: micrel: Advance register data pointer in write loop	2026-09-18 17:07:41 -07:00
microchip_rds_ptp.c	Convert 'alloc_obj' family to use the new default GFP_KERNEL argument	2026-02-21 17:09:51 -08:00
microchip_rds_ptp.h
microchip_t1.c	net: remove conditional return with no effect	2026-07-30 13:04:03 +02:00
microchip_t1s.c	net: phy: microchip-t1s: use generic C45 MMD access helpers	2026-07-21 10:53:24 +02:00
microchip.c	net: phy: microchip: enable downshift by default on LAN88xx	2026-04-02 18:03:03 -07:00
mii_timestamper.c	Convert 'alloc_obj' family to use the new default GFP_KERNEL argument	2026-02-21 17:09:51 -08:00
motorcomm.c	net: phy: motorcomm: enable the reference clock for YT8521	2026-08-03 17:48:37 -07:00
mxl-86110.c
mxl-gpy.c	net: phy: mxl-gpy: add PHY-level statistics via ethtool	2026-03-17 16:07:40 -07:00
national.c
ncn26000.c
nxp-c45-tja11xx-macsec.c	Convert 'alloc_obj' family to use the new default GFP_KERNEL argument	2026-02-21 17:09:51 -08:00
nxp-c45-tja11xx.c
nxp-c45-tja11xx.h
nxp-cbtx.c
nxp-tja11xx.c	net: phy: nxp-tja11xx: cancel registration work on remove	2026-08-05 17:50:03 -07:00
open_alliance_helpers.c
open_alliance_helpers.h
phy_caps.c	net: ethtool: Add support for 80Gbps speed	2026-01-19 12:09:58 -08:00
phy_device.c	net: phy: add generic helpers for direct C45 MMD access	2026-07-21 10:53:24 +02:00
phy_led_triggers.c	Convert remaining multi-line kmalloc_obj/flex GFP_KERNEL uses	2026-02-22 08:26:33 -08:00
phy_link_topology.c	net: ethtool: make dev->hwprov ops-protected	2026-06-09 10:13:04 -07:00
phy_package.c	net: phy: add PHY package locking helpers	2026-08-13 17:29:53 -07:00
phy_port.c	Convert 'alloc_obj' family to use the new default GFP_KERNEL argument	2026-02-21 17:09:51 -08:00
phy-c45.c	net: phy: c45: add setup and read master/slave helpers	2026-07-31 18:22:48 -07:00
phy-caps.h	net: ethtool: Add support for 80Gbps speed	2026-01-19 12:09:58 -08:00
phy-core.c	net: ethtool: Add support for 80Gbps speed	2026-01-19 12:09:58 -08:00
phy.c	net: phy: add a PHY write barrier when disabling interrupts	2026-04-12 14:19:19 -07:00
phylib-internal.h	net: phy: move remaining provider code to mdio_bus_provider.c	2026-03-14 12:23:02 -07:00
phylib.h	net: phy: add PHY package locking helpers	2026-08-13 17:29:53 -07:00
phylink.c	net: phylink: record the PHY only once bringup cannot fail	2026-09-24 09:36:05 -07:00
qsemi.c
qt2025.rs
rockchip.c
sfp-bus.c	Convert 'alloc_obj' family to use the new default GFP_KERNEL argument	2026-02-21 17:09:51 -08:00
sfp.c	net: sfp: add quirks for OEM XGSPONST2001 and FS XGS-SFP-ONT-MACI	2026-08-17 13:28:38 -07:00
sfp.h	net: sfp: allow prefix matching in quirk lookup	2026-08-17 13:28:38 -07:00
smsc.c
ste10Xp.c
stubs.c
swphy.c
swphy.h
teranetics.c
uPD60620.c
vitesse.c	net: phy: vitesse: add inband caps and configuration	2026-03-12 17:55:33 -07:00
xilinx_gmii2rgmii.c