mirror of
https://github.com/torvalds/linux.git
synced 2026-09-22 12:44:03 +02:00
cab40cfc9e
dw_i3c_master_daa() derives the number of newly assigned dynamic addresses from cmd->rx_len, the ISR sets it to the number of address slots ENTDAA left unassigned. It starts out as zero, which already means "every address was assigned", so a timed out transfer leaves that value in place and it gets used as a result. If there's no client connected, the addr assign cmd times out, then the driver calls i3c_master_add_i3c_dev_locked() to add devices that are not there, each costing about 1s, thus adds non necessary boot time up to (maxdev * 1)s. Start from maxdevs instead: no address is assigned before ENTDAA runs, and the existing rx_count >= maxdevs check then reports an empty bus. Signed-off-by: Jisheng Zhang <jszhang@kernel.org> Reviewed-by: Frank Li <Frank.Li@nxp.com> Link: https://patch.msgid.link/20260819044833.32611-1-jszhang@kernel.org Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com> |
||
|---|---|---|
| .. | ||
| master | ||
| device.c | ||
| internals.h | ||
| Kconfig | ||
| Makefile | ||
| master.c | ||