Convert CONFIG_IMX_SCU_PD from bool to tristate to allow building as a
loadable module. This is needed on Android devices using the Generic
Kernel Image (GKI), where SoC-specific drivers must be built as modules
rather than built into the core kernel image.
For i.MX8Q devices running Android with a GKI kernel, the SCU power
domain driver must be loadable. Without tristate support, power domains
cannot be properly initialized, preventing these systems from
functioning under GKI.
Use subsys_initcall() so that when built-in the power domain provider
probes before its consumers (e.g. the SCU clock driver at
device_initcall level), fixing "failed to attached the power domain"
warnings at boot. When built as a module, subsys_initcall() is
equivalent to module_init(). No module_exit() is provided because the
SCU power domain provider is a system-level resource that cannot be
safely removed at runtime.
Add MODULE_DEVICE_TABLE() for OF-based module autoloading.
Signed-off-by: Zhipeng Wang <zhipeng.wang_1@nxp.com>
Reviewed-by: Peng Fan <peng.fan@nxp.com>
Signed-off-by: Ulf Hansson <ulfh@kernel.org>
Convert IMX8M_BLK_CTRL and IMX9_BLK_CTRL from bool to tristate
to allow building as loadable modules.
This change is required to support Android devices using Generic Kernel
Image (GKI) kernels, where SoC-specific drivers must be built as loadable
modules rather than built into the core kernel image.
For i.MX8M and i.MX9 devices running Android with GKI kernels, the
BLK_CTRL drivers therefore need to be loadable. Without tristate
support, power domains cannot be initialized correctly, making these
systems non-functional under GKI.
Add prompt strings to make these options visible and configurable
in menuconfig, keeping them enabled by default on appropriate platforms.
Also remove the IMX_GPCV2_PM_DOMAINS dependency from IMX9_BLK_CTRL.
This dependency was incorrect from the beginning because i.MX93 uses a
different power domain architecture compared to i.MX8M series:
- i.MX8M uses GPCv2 (General Power Controller v2) for power domain
management, hence IMX8M_BLK_CTRL correctly depends on it.
- i.MX93 uses BLK_CTRL directly without GPCv2. The hardware doesn't
have GPCv2 at all.
Signed-off-by: Zhipeng Wang <zhipeng.wang_1@nxp.com>
Reviewed-by: Frank Li <Frank.Li@nxp.com>
Signed-off-by: Ulf Hansson <ulfh@kernel.org>
The Kconfig options belongs closer to the corresponding implementations,
hence let's move them from the soc- and firmware subsystem to the pmdomain
subsystem.
Cc: Shawn Guo <shawnguo@kernel.org>
Cc: Sascha Hauer <s.hauer@pengutronix.de>
Cc: Fabio Estevam <festevam@gmail.com>
Cc: Peng Fan <peng.fan@nxp.com>
Cc: <kernel@pengutronix.de>
Cc: <linux-imx@nxp.com>
Acked-by: Peng Fan <peng.fan@nxp.com>
Acked-by: Shawn Guo <shawnguo@kernel.org>
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>
